WARNING:
USE CAUTION TO NOT CONNECT THE WHITE AND YELLOW CONTROL WIRES TO ANY POWER SOURCE. IF THE WHITE AND YELLOW WIRES ARE CONNECTED TO ANY POWER SOURCE, EVEN BRIEFLY, THE UNIT WILL FAIL! NO WARRANTY CAN BE ALLOWED FOR ANY UNIT THAT HAS HAD THE WHITE AND YELLOW WIRES CONNECTED TO ANY POWER SOURCE.
Retro Fit Led Units Extended Version
Manual & Wiring Diagram
The extended version of the Retro Fit Light Unit will allow you to dim the LED lights as the dimmer is built in to the light. It is a 4-wire system. The black and red wires are the power input wires. The light will operate on a voltage range of 10-24 volts AC, or 10-30 volts DC.
The white and yellow wires are to be connected to a pulse (momentary) switch for on/off and dimming control.
For controlling multiple units in a single circuit simply connect the all yellow wires together and all white wires together and connect them all to the same pulse (momentary) switch.
Although the power to the lights may be provided from more than one source, as long as the unit’s yellow and white control wires are connected together the circuit may be operated by a single control switch. Additional pulse (momentary) switches may be paralleled together to allow for controlling the light circuit from more than one location.