Art. No.: DR010101
|Connection with||RGB LED Bars|
|Power source:||Input: 10V-24V AC or 10V-35V/DC|
|Output:||4.2V / 15A|
|Control Switch:||Pulse/Momentary Switch|
IF NOT CONNECTED PROPERLY, THE LED ENGINE WILL FAIL!
USE CAUTION TO NOT CONNECT THE WHITE AND YELLOW CONTROL WIRES TO ANY POWER SOURCE. IF THE WHITE AND YELLOW WIRES ARE CONNECTED TO ANY POWER SOURCE, EVEN BRIEFLY, THE UNIT WILL FAIL! NO WARRANTY CAN BE ALLOWED FOR ANY UNIT THAT HAS HAD THE WHITE AND YELLOW WIRES CONNECTED TO ANY POWER SOURCE.
Driver/Dimmer Manual & Wiring Diagram
RGB LED Bars
The DR010101 Driver/Dimmer is for use with the RGB LED Bars with 4.2V/DC input.
A pulse (momentary) switch is required to control the driver.
The green, blue, grey and red wires should always be connected with similar coloured wires. This is extremely important because the LED’s are sensitive to polarity.